CleanSpace CS302 User Instructions Download

Page: 6 / 90

The HALO half masks are approved and may be used without the Head Cover with either the HE Filter HALO BIO
(CS3025) or the HALO Standard HE Filter (CS3022). When configured with either of these filters, the HALO half
masks are approved and may be used with either the Standard Exhalation Valve Cover or the BIO Exhalation Valve
Cover.

The CS3038 Steri-Plus Exhalation Filter Case and the CS3039 Steri-Plus Exhalation Filter shall only be used in
combination with a HALO Half Mask fitted with the PAF-1111 Standard Exhalation Valve Cover. The Steri-Plus
Exhalation Filter shall NOT be used with the Head Cover. Note: The HALO Exhalation Filter does not provide or
contribute to the system’s respiratory protection. An HE Filter (CS3022 or CS3025) must be used.

The CS3027 HALO BIO Exhalation Filter shall only be used in combination with a HALO Half Mask fitted with the
CS3026 HALO BIO Exhalation Valve Cover. The HALO BIO Exhalation Filter can be used with or without the Head
Cover. Note: The HALO BIO Exhalation Filter does not provide or contribute to the system’s respiratory protection.
An HE Filter (CS3022 or CS3025) must be used.

Ensure that either the Standard Exhalation Valve Cover or BIO Exhalation Valve Cover (as applicable for the
intended configuration) is installed prior to use.

7. Limitations of Use

Use this Respirator strictly in accordance with all instructions in these user instructions and NIOSH Approval Labels.
Never modify or alter this product.



Do not remove the Respirator until you have left the contaminated area

unless you have pressing health reasons to do so (for instance you are experiencing dizziness and
believe removing the respirator while you leave the contaminated area may help).



Only suitable for use by clean-shaven personnel. Facial hair under the seal reduces protection and is not

permitted.



Note: Half Mask variants of CleanSpace do not protect your eyes. In conditions that may damage or

irritate eyes, use protective eyewear or a full-face variant of CleanSpace.



Only use your respirator with the parts and accessories listed on the Approval Label.



Do not use the respirator unless it is powered and running normally.



Do not use the respirator while it is being charged via the AC adaptor.



Do not use in airborne contaminant concentrations above those specified in your national regulations.



Do not use for respiratory protection against unknown atmospheric contaminants or when concentrations

of contaminants are unknown or immediately dangerous to life or health (IDLH).



Do not use in oxygen deficient or oxygen enriched atmospheres. Do not use in flammable or explosive

environments.



Only for use by trained personnel.



Filters need to be changed regularly. The frequency of change depends on use and the concentration of

contaminants in the atmosphere.



Do not use for escape purposes. National regulations may impose specific limitations on the use of filters

depending on the filter class and the facemask used.

LEAVE THE CONTAMINATED AREA IMMEDIATELY IF:



respirator warning lights and/or sounds activate for low battery or blocked filter



any part of the respirator is damaged



air flow into the mask decreases or stops



breathing becomes difficult or increased resistance occurs



you feel dizzy or your airway is irritated



you can taste or smell contaminants.

Your respirator is suitable for use in the following atmospheric conditions:



Temperature: 14°F to 113°F (-10°C to 45°C).



Relative humidity: 0 to 90% non-condensing.

The respirator will stop functioning if its internal temperature rises above 140°F (60°C) or falls below 14°F (-10°C).
If the respirator has been used in an area that has caused it to become contaminated with a substance requiring
special decontamination procedures it should be placed in a suitable container and sealed until it can be
decontaminated.