2. GENERAL DIRECTIVES AND REFERENCES
ELECTRICAL GROUNDING SPECIFICATIONS
The system’s power unit must absolutely be grounded. In the event of a malfunction or a
power unit failure, the grounding provides the path of least resistance to any electrical
current, minimizing the risk of electric shock. The power unit’s power cord has a length of
65’’ (1,65m) and is fitted with a grounding wire and grounding pin. The power unit‘s power
cord must always be directly plugged into a suitable electrical outlet which is itself properly
installed and properly grounded, in conformity with the current local electrical standards.
Do not use extension cord(s) to connect the power unit to the electrical outlet.
WARNING
Improper connection of the power unit grounding wire can result in the risk of electric shock.
If you are in doubt of a proper grounding, contact a professional electrician. Do not modify
the power cord supplied with this power unit. If this power cord connector does not fit your
electrical outlet, have the proper electrical outlet installed by a professional electrician. This
power unit is designed to be used on a nominal electrical circuit of
10 A. 220-240 V in 50-60
Hz
. The power cord is fitted with a grounding pin. Make certain that the power cord is
plugged into an electrical outlet having the same specifications. This appliance should be
used without an adaptor. This power unit should be
installed on its own independent circuit and breaker.
IMPORTANT
The manufacturer shall not be held responsible for damages cause by the inappropriate use
of this system. The warranty does not cover the damages caused by an inappropriate use of
this system nor the problems resulting from an installation which does not meet the
specifications, nor any structural or functional alterations made to the power unit. An
inappropriate, not-recommended installation
of the system or the power unit made without respecting the directives of this document will
equally be considered as misuse. All conditions and restrictions are set forth in the limited
warranty and in the user manual. To optimize the performances and the life of your central
vacuum system, it is important to do regular maintenance and cleaning of the filter according
to the guidelines listed in this user manual.
General guidelines to be respected at all time
1. The power unit must be installed in a well ventilated area, protected from weather and away from
all sources of heat.
2. This central vacuum system is design for dry surfaces only and must not be used on wet surfaces
nor be used in any circumstances to pick up liquids or to clean wet carpets or any wet ground.
3. The filter cage must be covered at all times by the permanent filter during operation of the system.
4. The motor housing must never be obstructed in any way to prevent damaging or overheating.
5. Do not use this system to pick up mud or similar substances. To vacuum baking flower, talcum
powder, cement or gypsum dust, will have for effect to obstruct and clog the filter media; you have to
clean the filter several time
during and after such pick-ups. Otherwise the motor will overheat and may be damaged.
6. Do not attempt to shorten or modify the power cord in any way.
7. As a safety measure, unplug the power cord prior to proceed to maintenance or servicing.
8. In order for the warranty to remain valid; any repairs or servicing on the power unit must only be
performed by an
authorized service centre.
