2
Thank you for buying CleanSweep
®
rack
-
mounted PDU (power distribution unit)!
Your new CleanSweep
®
PDU will provide your sensitive equipment with AC power
free from electromagnetic interference (EMI) and power line transients. Such
artifacts on power lines and ground cause numerous equipment malfunctions, in-
cluding lock
-
up, erratic response, software errors, and other often
“
unexplained
”
behavior. Excessive transients and noise can also cause damage to sensitive
components via induced electrical overstress (EOS). For more details on this subject
please visit
Library
section on our web site
www.onfilter.com
.
Safety First!
CleanSweep
®
PDUs operate with high voltage that, improperly installed or used, may
cause property damage, injury and death. Always observe safety measures when
using power line filters. Here are some of the key safety precautions you should
take:
WARNING
•
Do not exceed PDU
’
s maximum rating
-
it may cause overheating
•
Use PDU after the fuse or circuit breaker of no more than specified max. rating
•
Use only with the power cord supplied by manufacturer
•
This PDU is not for household use
•
PDU must be plugged into a properly wired grounding type outlet
•
No serviceable parts inside
-
do not open. High voltage is present inside.
Introduction
CleanSweep
®
EMI PDUs reduce noise on power lines providing clean power to your
equipment. High levels of noise (also called conducted
El
ectro
M
agnetic
I
nterference
-
EMI) interferes with normal operation of electronic equipment and
can cause physical component damage inside the equipment. Noise on power lines
is common in industrial and office environment and the only practical way to deal
with it is by using properly
-
designed filter which is a part of CleanSweep® PDU. In
addition to effectively suppressing EMI, OnFILTER
’
CleanSweep
®
PDU provides
advanced transient surge protection by reducing power line transients down to
insignificant levels surpassing conventional surge protection.
Installation
Proper installation of PDU helps to assure its continuous operation for a long time.
Please follow these requirements for installation:
•
Use PDU in a dry location away from debris and from the possibility of spillage,
including from cleaning
•
Ambient temperature at the place of installation should not exceed the range of
5
0
…40
0
C
•
Firmly fasten PDU in a
19”
rack using all four screw (supplied)
•
Install filter close to your equipment
•
Do not install PDU in small confined spaces with restricted air circulation in or-
der to avoid overheating. Allow some space on each side for proper ventilation
7
w
w
w
.on
fil
te
r.c
om
w
w
w
.onf
ilte
r.com
Mechanical Specification
Material
Powder
-
coated aluminum
Dimensions
See drawing below
Mounting
19”
rack, 2
-
Up
Included
AREC144FG PDU
1 ea.
Power cable NEMA5
-
15 to C13, AWG14
1 ea.
Mounting screws 10
-
32
4 ea.
This User
’
s Guide
1 ea.
