10 Pentz EF5 Installation Guide
© Clear Vue Cyclones 2018
Constructing the Motor Assembly
1. Locate the motor plate – it is the round disc secured to the top of the Blower Housing.
a. Remove the bolts and washers using a
9
∕
16
” wrench and set hardware aside.
2. Stand the motor on end, with the shaft facing up towards the ceiling.
3. Install (1)
3
/
8
"-16 x ¾" hex
bolt through each of the holes on the motor plate, into the holes on the
face of the motor, using (1)
3
∕
8
” lock washer and (1)
3
∕
8
” flat washer per bolt.
For three phase motors, substitute with ½"-13 x 1" hex bolts, ½" lock washers and ½" flat
washers.
4. Tighten each motor bolt securely.
Do NOT turn the motor on until the system is completely
assembled, including the collection drum. Doing so may cause
the circuit breaker to trip, physical damage to the system and/or
bodily harm.
