User manual
Page 12
© clearaudio electronic GmbH, 2022-11
Please pay attention that the exchanged
Master Innovation
pulley is flush mounted with the axis of
the motor.
Pic. 10:
Setup of the
Master Innovation pulley
Now the upgrade from the
Innovation
to the
Master Innovation
is completed and you can switch
over to the setup of the
Master Innovation
.
In the user manual for the
Master Innovation
you will find the packing list, packing overview and of
course the whole description for the setup of the
Master Innovation
.
To make it easier for you, you can also go ahead with the following description:
7.)
In the next step remove carefully the lamination of the sensor on the upper surface of the turntable
chassis.
Please remove the lamination extreme carefully and avoid any soiling and scratches.
Take the stainless steel sub-platter again carefully with both hands and put it onto the bearing.
The lower side must show to the bearing. Through a lightly (!!) up and down movement the platter
will slip onto the bearing upper part (Pic. 11 and 12).
Please remove the lamination extreme carefully and avoid any soiling and scratches.
Pulley for
Master Innovation
Distance is approx. 1,2 mm
Pic. 11:
Setup of the sub platter
Pic. 12:
Setupf of the sub platter