User manual
Made in Germany
Page 15
11.)
Take the stainless steel sub-platter out of the box 3 and remove only the protection sheet, but keep
the protection film of the upper side of the sub-platter.
Put the sub-platter very carefully onto the upper part of the bearing (Pic. 15a).
Now take the main platter out of the box and set it up onto the upper part of the bearing.
The recess for the label must be faced upwards. Now you can carefully remove the protection film
(pic. 15b). To avoid any damages on your bearing, the Delrin platter should have room temperature
before the setup begin (approx. 20 ° Celsius).
Avoid major side forces to avoid any damages to the ceramic bearing!
Pic. 15a:
Setup of the stainless steel subplatter
Pic. 15b:
Setup of the main platter
Pic. 16:
Finished setup
