Page 9
Topside Control Option (Hot Tubs Only)
Topside control found on some hot tubs
Topside Ionizing Indicator
When the mode of the controller is set to “Ion/Action” and the “Ionizing” light is illuminated on the
controller, the area in the center of the topside control will illuminate in blue.
Topside Large Dose Function
Press the center of the logo to
engage the “Large Dose” mode for the number of hours programmed on
the controller. When “Large Dose” is active, the area in the center of the topside control will flash in
blue. Once the cycle expires, the controller will go back to “Ion/Action”, the cente
r area will illuminate in
blue and the flashing will stop. To stop the Large Dose mode before the cycle finishes, hold down the
button in the center of the logo for 10 seconds.
Turn Off Ionizing
If the mineral level is too high, or you would like to shut off the ionizing for any other reason, hold down
the button in the center of the logo for 10 seconds or until the blue light goes off.
Turn On Ionizing
If the ionizing function has been turned off, press the button in the center of the logo to turn it back on.
The center of the logo will illuminate in blue to indicate that the system is ionizing.
Topside Cell Connection Indicator
When the mineral cell is unplugged, the electrode bars are not under water, or the cell is worn past its
useful life, the light in the center of the topside control will flash red.
Replacing the Mineral Cell
The mineral cell will last 3
–
12 months depending on the size of the pool, the temperature of the water,
the amount and intensity of sun reaching the water, and pool usage. The first cell will always wear down
faster because it is used up quicker to ramp up the minerals.
Unplug or turn off the power to the controller before plugging in or unplugging the cell. Otherwise,
you could damage the control board.
It is important to check the cell regularly and make sure there is still some material left on the bars. If
the bars are worn down to 0.5” (10mm)
in length or below, it is time to change the cell. When the cell is
completely used up, the ‘Ionizing’ light w
ill flash red.
