Page 8 of 15
P/N G0200177 Rev A, 1.0.03.03.2016
ClearCube Technology, Inc.
3700 W Parmer Lane
Austin, TX 78727
(512) 652-3500
www.clearcube.com
Setting up an M1032W Engineering Workstation
M1032W
cabling
This section shows how to connect cables. Numbers in parentheses correspond to labels shown in “
M1032W rear ports and connectors
” to ease identification.
Step
Action
1
Install the included
mounting rails
to the server chassis and then install the chassis in a rack.
2
From the rear of the chassis, use the included video cables to route video from the PCoIP host
card to the GPU. Use the included DP-to-mini-DP cables.
“
” below shows pictures of every GPU and PCoIP Host Card combination.
Find your configuration in the table’s Card Configuration column and connect cables as shown
in the corresponding picture.
3
Connect an Ethernet cable to the dedicated
PCoIP LAN port
(20) and connect the other end
to a network router or switch.
4
Optionally, connect one or more Ethernet cables to the
LAN ports
(13) and (14) on the rear
of the chassis and connect the other end of the cable(s) to a network router or switch.
5
If your configuration includes a fiber NIC (18), connect a fiber Ethernet cable to the
Fiber
NIC
(18) on the rear of the chassis and connect the other end of the cable to a network
router or switch.
6
Optionally, connect one or more Ethernet cables to the
Dedicated IPMI port
(10) on the
rear of the chassis and connect the other end of the cable to a network router or switch.
7
From the rear of the chassis, connect the included
power cable
to the
power connector
(21) on the rear of the server, and connect the power cable to a power outlet.
8
From the front of the chassis, press the
power button
(7) to power on the server.
Continued on next page