FieldSmart
®
Fiber Active Cabinet (FAC) 400
Installation Manual
_________________________________________________________
Proprietary Information: Not for use or disclosure except by written agreement with Clearfield.
114
Step 1:
Step 2:
Installing the Fiber Management Accessories
This topic describes how to install the fiber management accessories kit, comprised of a spool bracket and a comb bracket
for dressing fiber.
Note:
When the accessory kit is ordered as an FAC 400 factory option, these items are installed in the cabinet at the factory.
To install the FAC 400 fiber management accessories
Accessing the compartment from the side door, remove the bracket that is located directly below the protection
panel mounting frame.
a. Remove the (2) screws on the vertical-rail side of the frame. Remove the (2) nuts on the wall side of the
frame.
b. Remove and discard the bracket, but retain the hardware for reuse.
Install the comb bracket into the vacant position on the mounting frame.
a. Position the comb bracket on the mounting frame as shown, aligning with the (2) holes in the frame.
b. Secure the comb bracket in place reusing the (2) screws and nuts removed in Step 1.
