FieldSmart
®
Fiber Active Cabinet (FAC) 400
Installation Manual
_________________________________________________________
Proprietary Information: Not for use or disclosure except by written agreement with Clearfield.
42
On the left side of the cabinet, remove the five plastic caps
covering the bracket mounting holes.
Attach the top bracket to the cabinet as follows:
a.
Position the top bracket against the left cabinet wall, aligning
the bracket holes with the counterpart holes on the cabinet.
b.
Insert (5) 1/4-inch hex head screws (with flat and lock
washers) into the bracket holes.
c.
Tighten the screws completely to secure the bracket in place.
Install the cabinet onto the mounting fixture.
Perform the remaining step only after the cabinet is
installed on the mounting fixture.
Attach the top bracket to the pole as follows:
a.
While holding the top bracket against the pole, drill (2) 3/8-
inch
pilot holes into the pole through the holes in the bracket.
b.
Install (2) 1/2 x 5-inch lag screws (with 1/2-inch flat washers)
into the pilot holes. Tighten the bolts completely to secure the
bracket in place.
c.
Install the steel bolt-a-band through the slots in the top brack-
et, around the pole, and back into the band retainer.
d.
Pull the band tight (to 20 ft-lbs.) and tighten the nut on the
bolt to secure it in place as shown below.
Step 1:
Step 2:
Step 3:
Step 4:
To install the top bracket