119
FieldSmart
®
Fiber Active Cabinet (FAC) 900
__________________________________________________________
Installation Manual
Direct: 763.476.6866 • National: 800.422.2537 • www.SeeClearfield.com • techsupport@clfd.net
Manual 020420 REV B - April 2019
Step 4:
Step 5:
Step 6:
Place the pad from the shipping package at the base of the enclosure under the cross-connect frame on the
right side.
Prepare the cross-connect panel for installation as follows:
a.
Separate the subscriber cables and the equipment cables. (The cables are labeled 'Subscriber' and 'Equip
-
ment.')
Note:
To ease installation, it may be advantageous to remove some of the cable bundle tie wraps in some
applications.
b.
Orient the panel face down with the bottom of the panel toward the rear of the enclosure, and then route the
cables under the cross-connect frame.
c.
Lay the cross-connect panel on the pad.
Terminate the cables as follows:
a.
Mate the equipment-side cables to the appropriate protection panel interface cables (MS
2
or 710 connec-
tors), toward the left access panel.
b.
Mate the subscriber-side cables (193-384) to the appropriate OSP interface cables (MS
2
or 710 connectors),
toward the rear access panel.
