Proprietary Information: Not for use or disclosure except by written agreement with Clearfield.
66
FieldSmart
®
Fiber Active Cabinet (FAC) 900
Installation Manual
_________________________________________________________
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Slowly lower the cabinet or riser onto the pad, keeping the mounting holes in the cabinet base aligned with the
anchor studs (or holes) in the pad.
Note:
If properly aligned, the entry ducts should slide down over the conduits as the cabinet or riser lowers. If
necessary, trim the conduit down to a height that enables it to pass into the entry duct.
Trim the AC sealing boot so that the open diameter is slightly smaller than the conduit to provide a water-tight
seal.
Pull the earth ground wire into the cabinet or riser through one of the cable entry ducts.
Anchor the cabinet or riser to the pad as follows:
• Site-cast pads with anchor studs:
a.
Get the four hex nuts, four flat washers, and four lock washers from the installation kit.
b.
Install one flat washer, lock washer, and hex nut onto each of the four anchor studs.
c.
Tighten the hex nuts to secure the cabinet or riser to the pad.
• Pre-cast pads with threaded inserts:
a.
Get four anchor bolts, four flat washers, and four lock washers from the installation kit.
b.
Install one flat washer, lock washer, and anchor bolt into each of the four threaded mounting inserts.
c.
Tighten the bolts to secure the cabinet or riser to the pad.
Verify that the doors open and close freely. If necessary, use shims to level the cabinet or riser.
Note:
If you removed the doors previously, re-install them to check door swing alignment. See Installing a
Cabinet Door for instructions.
Clearfield recommends applying silicone caulking to the bottom perimeter of the cabinet or riser once the installation is
complete.
To install the cabinet on the riser
Using two people, lift the cabinet onto the riser, keeping the (4) anchor holes in the cabinet base aligned with
the counterpart holes in the riser.
Attach the cabinet base to the riser using (4) anchor bolts, (8) flat washers, (4) lock washers, and (4) nuts (one
set per each of the four anchor holes).
Tighten all hardware to secure the cabinet to the riser.
Step 1:
Step 2:
Step 3:
