Direct: 763.476.6866 • National: 800.422.2537 • www.SeeClearfield.com • techsupport@clfd.net
2
Field Installable FlexConnector for Generic Cable
Installation Manual
_________________________________________________________
Manual 019609 REV A - Jul 2018
Step 11
:
Push strength member loop
in through FlexConnector hole and out
the larger end of FlexConnector
Figure 11
Step 12
:
Feed kevlar strands through
the strength member loop.
Figure 12
Step 13
:
Pull kevlar strands through
FlexConnector hole with strength
member loop.
Figure 13
Step 14
:
Kevlar strands should now
pass from large end of FlexConnector
through FlexConnector hole.
Figure 14
Step 15
:
Now guide 3mm breakout in
through large end of FlexConnector
and out through small end.
Figure 15
Step 16
:
Slide smallest, 5/16” x 3”
long (004458) heat shrink flush with
FlexConnector and shrink with heat
gun.
Figure 16
Step 17
:
Slide medium, 1/2” x 2 1/4”
long (004644) heat shrink flush with
FlexConnector and shrink with heat
gun.
Figure 17
Step 18
:
Pull kevlar strands taught
and slide largest, (1) 3/4” x 2 1/4” long
(004867) over FlexConnector.
Figure 18
Step 10
:
Locate the FlexConnector
hole on FlexConnector.
Figure 10
FlexConnector
Hole
