Note :
Do not fill higher than indication “max” of the
water tank in order to avoid spilling out of water.
Do not fill with anything but water. If you have to
refill while ironing, remove the mains plug from
the wall socket before filling.
Pour out any remaining water after use.
Insert the plug in the wall socket and stand the
iron upright
Set the temperature control dial (1) to the correct
temperature as indicated in the ironing instruction
or in the label.
The correct temperature will be reached when the
indication light has gone. The indication light will
be on and off from time to time indicating that the
selected temperature is being maintained.
Setting the temperature
Spraying
At any temperature by pressing on the spray
button (5) a couple of time, the laundry can be
damped down
Ensure that there is enough water in the water
tank.
Steam – Ironing
As indicated on the temperature control dial and
the temperature table, steam ironing is only
possible at higher ironing temperature.
*** or MAX for maximum steam.
Ensure that there is enough water in the water
tank.
Stand the iron on its rear side.
Insert the plug into the wall socket.
Set the temperature control dial (1) at the
required position with the higher ironing
temperature range
*** or MAX
Wait a little while for the indication light (7) to go
out and to come on again.
Set the steam control dial (4) to the required
position. Then the steam will emerge from the
vents in the soleplate.
Notice:
Water may leak from the soleplate if the
temperature selected is too low, or if steam is
used continuously for some time. This will then
cause stains if it happens, set the temperature
slide control to the advised position. Steaming will
re-commence as soon as the appropriate
temperature has been reached.
5
fig.4
5
