SHOT OF STEAM
Set the temperature control dial (1) to the “MAX”
position.
By pressing the steam button (6) a Shot of Steam
is emitted from the soleplate.
This can be very useful e.g when removing
stubborn creases. The Shot of steam facility can
be used only while ironing with high ironing
temperature (positions *** or “MAX”).
Dry ironing
Insert the main plug into the wall socket.
Ensure that steam dial (4) is in dry position
Select the setting on the temperature control dial
() best suited for the fabric to be ironed.
When the indication light is gone, ironing may
commence.
Self clean
(Auto clean system)
To prolong the life of your iron, we recommend
that this be carried out at regular intervals (once
or twice a month)
Set the steam dial (4) to dry position
Fill the water tank to the symbol “MAX”
Stand the iron on its rear side
Insert the mains plug into the wall socket
Set the temperature control dial (1) to “MAX”
Allow the iron to heat until the indication light (7)
first goes out
Unplug the iron and keep it horizontally over a
sink
Set the steam dial
(4) to self
clean symbol and lift the dial
Impurities and scale
(if any) are washed away from the steam vents in
the sole plate.
When the output of steam has diminished, put the
steam dial back into the position and reset the
steam dial (4) to dry position.
Insert the mains plug into the wall socket and let
the iron heat up again.
Move the iron over an old place of cloth in order to
let the remaining water vaporize.
Remove the plug from the wall socket and wait for
the soleplate to cool down completely.
Make sure that the soleplate is completely dry
before storing it.
Care and cleaning
Before cleaning the iron, ensure it is
disconnected from the power supply and has
completely cooled down.
Deposits and other residues on the soleplate can
be removed with a rough cloth soaked in a
vinegar/water solution.
6
4
fig.6
