48 – ENGLISH
Noise, Static, Interference while using the phone
1. A filter may be required for your home when you have DSL
service or live near radio towers.
2. Make sure the AC adapter is not plugged into the wall outlet
with other appliances.
3. Try relocating the phone to another location.
No numbers dialed when memory button is pressed
1. No number stored in that memory button (page 29).
2. Make sure phone number was programmed and saved
(page 29).
3. Make sure programming is done in the correct dialing mode
(touch-tone or pulse).
Caller ID information does not show
1. Make sure you are subscribed to Caller ID service through
your local phone company.
2. Let the phone ring a couple of times as there may be a delay
in receiving the Caller ID information.
No Caller ID information while on a call
1. Make sure you service provides Caller ID information while
you are on a call. This is sometimes known as “Caller ID on
Call Waiting” or “Type II Caller ID”.
2. The phone cannot display the information if another phone
on the same line is in use.
When I try to the set time, some numbers won’t enter
1. You must enter leading zeros, and you must enter the time in 24-
hr format, even if you set the time to display in 12-hr format.
2. Enter 00:00, and then try again to enter the correct numbers.
Bluetooth headset doesn’t work
1. Ensure that the headset is On and at least partially charged
(page 44).
2. Ensure that the headset is within 9 feet of the handset.
3. Ensure that Bluetooth is On in the handset (page 44).
4. Ensure that the headset is paired and connected with the
handset (pages 42-43).
5. Ensure that you press
on the handset to answer, place or
switch a call.
A blue light is flashing in the dome at the top of the handset
1. Bluetooth is set ON, and the handset is attempting to connect
to a paired Bluetooth headset.
2. To turn off Bluetooth: (page 44).
To connect with a paired headset: Turn on the headset (page 44).
