9. With the end panel situated on a flat, clean surface,
insert the assembled bottom end frame tube into the
pocket at the bottom of the front end panel.
10. Once the frame tube is fully inserted into the end
panel pocket, reattach the frame tube to the band
clamps as previously described.
NOTE:
Depending on the width of the greenhouse and
the end panel, it may be necessary to cut or trim the end
panel pocket to reattach the frame member between the
ground posts.
If this is necessary, center the panel on the bottom end
frame tube before cutting the panel.
11. With the bottom frame tube reattached to the ground
posts and tightened, place two band clamps
(QH1402) near the top of the end rafter where the
vertical doorframe tubes will be attached.
12. After placing the band clamps in position near the
top of the rafter, pull the end panel up and over the
top of the end rafter and secure it to the inside of the
end rafter using fabric clips and Tek screws.
NOTE:
Do not remove the excess end panel material at
this time.
13. After attaching the end panel to the end rafter,
continue by attaching the doorframe tubes to the
end wall bottom frame tube and end rafter.
ATTACH VERTICAL DOORFRAME TUBES
The following steps describe how to attach the vertical
frame members to the end rafter.
1. Locate the band clamps previously placed near the
top of the end rafter.
NOTE:
You may need to loosen the fabric clips in these
locations to access the band clamps.
2. Move to the bottom frame tube of the end frame and
locate the center of the frame tube.
3. Using a utility knife or scissors, cut through the end
panel pocket covering the end frame tube and locate
the center mark previously made on the end tube.
Visit www.ClearSpan.com for additional products and customer assistance.
15 of 24
