Cover has been removed to show the cover conduit that
the strap wraps around.
NOTE:
Verify that the cover is centered side-to-side
before attaching the straps.
13. Repeat the steps for the remaining D-Rings and
straps.
NOTE:
All D-Rings and strap assemblies are installed on
the same side of the greenhouse. Ratchets are attached
directly across from the D-Rings and straps on the same
rafter assembly.
14. Move to the other side of the greenhouse and attach
the ratchets to the rafter legs. Use the main cover
conduit as a guide when attaching the ratchets to
the rafter legs at the proper height.
15. As previously described, make a slit in the cover
conduit pocket and insert a section of strap through
the slit and around the cover conduit.
16. Thread the strap into the ratchet and slightly tighten.
NOTE:
It may be necessary to remove excess strap if it
binds up in the ratchet.
The above diagram is used for illustration only. It shows
a different but similar greenhouse frame.
17. Repeat the steps for the remaining ratchets.
18. Using additional help (if needed) tighten the main
cover beginning with the ratchets along the side of
the greenhouse frame.
19. After the side ratchets are tightened, return to the
front and back end wall ratchets and tighten those.
NOTE:
Loosen the ratchets if needed to remove excess
strap. If the main cover is not centered as desired, the D-
Rings and strap assemblies can be reposition (higher or
lower) as needed and the main cover retightened.
20. Fold the skirt of main cover down and over the
ratchets and D-Ring Straps to complete the
installation of the main cover.
21. Continue by reading the
Greenhouse Care and
Maintenance
information that follows.
Cover Conduit
Visit www.ClearSpan.com for additional products and customer assistance.
21 of 24
