5
CLEARSPAN
™
CEDAR GREENHOUSES
Revision date: 06.18.09
1
ASSEMBLE BASE FRAME
Consult the
Assembled Base
and
Exploded Base Views
at the back of these instructions to assemble the
base frame.
NOTE:
All screws in this step are installed in the sides of the baseboards. DO NOT install screws into the
top of the baseboards.
Gather the correct board lengths and assemble the
1.
sideboards
using two (2) middle connectors; one
placed over the top edge and one placed over the bottom edge at the joint between the boards. Use
3/4" Phillips head screws (FAF25P) to secure middle connectors.
With the baseboards assembled, locate one front/back board, one sideboard, and a corner bracket.
2.
Assemble corner as shown below using 3/4" Phillips head screws (FAF25P) to secure. Repeat at the
remaining corners.
On the
3.
outer sideboard
, attach pass-thru connectors (#104639) in the locations shown below. Consult
the
Assembled Base View
for the correct measurements and locations. Use 3/4" Phillips head screws
(FAF25P) to secure pass-thru connectors.
Consult the diagrams near the back of these instructions
4.
to square and anchor the assembled frame
.
INNER SIDEBOARD
OUTER SIDEBOARD
BACK
FRONT
1
VER
TICAL
W
ALL
Diagram shows vertical
wall surface to which the
greenhouse is attached.
Outside
Inside
Align the
centers of the
connectors with
the measured
marks.
3
ATTENTION:
Verify that the
front and backboards
are seated
against the corner brackets.
2
SIDEBOARD
BACKBOARD
