ClearSpan NorthStar Garage, Instruction Manual

15

CLEARSPAN

™

 POLY BUILDINGS

Visit 

www.ClearSpan.com

 for additional products and customer assistance.

Cover Conduits

Cover 

Ends w/

Strapping

2.  After assembling the cover conduits, locate the main 

cover and unfold it on a clean, smooth surface near the 

frame.  

NOTE:

 Unfold the main cover with the inside surface 

facing up.

3.  Locate the cover ends with strapping and align with the 

front and back of the shelter.

4.  Insert the cover conduits into the pockets of the main 

cover. 

PREPARE MAIN COVER (CONTINUED)

ATTACH MAIN COVER

Gather the parts:
•  Main cover (with conduits already inserted)
•  Ropes long enough to reach over the frame (provided 

by customer)

•  Box cutter or utility knife 

Assembly Procedure
1.  To pull the cover over the frame, attach ropes to both 

ends of the cover conduit. Wrap the rope around the 

conduit a few times to prevent it from slipping off. 

2.  With the necessary ropes attached to the cover 

conduit, lift the conduit and carry the cover toward the 

base of the frame.

3.  Toss the ropes over the frame and pull the cover into 

position. One person is required at each rope.  

NOTE:

 Use lifts and additional assistants (if needed) to 

help pull the cover up and over the frame.

4.  Once the main cover is pulled into position, center the 

cover on the frame.  

WARNING:

To prevent damage and injury, do not leave 

the cover unattended if it has not been secured.

 The 

ropes can be used to temporarily keep the cover from 

sliding or blowing off the frame.

5.  Tie the ropes (or straps), used to pull the cover into 

position, to the frame to help hold the cover.

6.  Move to the other side conduit of the cover and 

temporarily secure that side of the cover to the frame. 

NOTE:

 Tie ropes to the ends of the side conduit and 

directly across from the ropes or straps tied to the other 

side conduit to temporarily secure the cover to the 

frame.  

7.  Continue with the installation of the side straps.

Cover 

Conduit

Ropes

NOTE:

 Depending on the length of the cover it may 

be necessary to attach additional ropes to the cover 

conduit between the end ropes by cutting a small 

opening in the cover pocket and tying the rope around 

the conduit. DO NOT cut through the main cover. 

Cut 

through the conduit pocket only.