43
Revision date: 05.13.10
Film Cover Installation with Roll-Up Sides
ATTACH CONDUIT TO ROLL-UP SIDE FILM
Gather the parts:
Assembled conduit
•
Fabric clips #CC6212
•
(Divide quantity in half.)
Tek screws
•
(#FA4482B)
To this point, the roll-up side film along one side is secured
to and hanging down from the double U-channel. The
assembled roll-up conduit should be positioned on the free
end of the side roll-up file.
Roll the assembled conduit onto the edge of the roll-
1.
up film.
Verify that the film and conduit are evenly positioned,
2.
and, using half of the #CC6212 fabric clips and
FA4482B screws, secure the film to the conduit.
Evenly space the clips along the length of the conduit.
NOTE:
Twist the conduit in a direction that wraps the
film toward the inside of the frame. This allows water
to drain off the building and roll-up film.
Continue to roll the conduit until the excess film
3.
material is wound around the conduit and the lower
edge is positioned at the base of the frame.
Temporarily anchor the conduit and curtain to the
4.
frame or ground
and repeat the steps to complete the
installation of the roll-up side panel for the remaining
side of the building up to this point
.
With the excess roll-up side film rolled on the conduit
5.
assemblies, continue with the installation of the Twist-
of-the-Wrist components for the roll-up sides.
ASSEMBLE THE ROLL-UP SIDE CONDUIT
Gather the parts:
Pipe 1.315'' x 75'' swaged (#131S075)
•
Tek screws
• (#FA4482B)
The roll-up side conduit assembly attaches to the bottom
edge of the roll-up film material. This assembly runs the
length of the frame and serves as the center pipe that the
roll-up film wraps around when it is opened to ventilate the
shelter.
Complete these steps to assemble the roll-up side
conduit.
Locate all sections of pipe (#131S075) needed to
1.
assemble the roll-up film conduit.
Insert the swaged end of each pipe into the plain end
2.
of another pipe until the conduit is assembled.
Secure each pipe joint with a Tek screw (FA4482B)
3.
and tape over the screw using duct tape.
Place the assembled conduit on the lower edge of the
4.
roll-up side film.
Center the conduit end-to-end, allowing at least 6" of
5.
pipe to extend beyond the end rafters. Pipe can be
trimmed later if desired.
ATTENTION:
In some instance, you may need to trim
the pipe to length and use the remaining section to
complete the assembly of the other roll-up conduit.
Count the pipes to verify that you have enough to
complete the assembly of the remaining conduit.
Consult the Twist-of-the-Wrist Assembly procedure on
the next page for diagrams that show an assembled
roll-up side.
Continue with the procedure that follows to attach the
6.
conduit to the roll-up side panels.
Inside View
Ground Level
Roll side panels so they
wrap on the inside or
underside of the panel.
