45
Revision date: 05.13.10
Select the bearing bracket and attach the bearings as
6.
needed. (In some instances, the bearings may come
already attached.) Assemble as follows if needed:
NOTE
: Single bearings are attached to the sides of
the bracket and double bearings to the middle portion
of the bracket. Use 1/4" hex bolts and locknuts as
needed. Install a flat washer on both sides of each
bearing to insure proper operation of bearings and the
assembly.
Install the longer bolts with bearings on the side of the
7.
bracket that has the two holes. Install these
before
installing the double bearing assembles. See the
figures below.
For the spacers on the long bolts, insert a 5/16" nut
8.
over each bolt.
These nuts are used as spacers only.
5/16" Nut
5/16" Nut
Slide the Twist-of-the-Wrist mounting plate over the
9.
long bolts and secure the plate with two lock nuts.
Lock Nuts
Attach the Twist-of-the-Wrist gearbox to the mounting
10.
plate using hex head bolts.
TWIST-OF-THE-WRIST ASSEMBLY (continued)
Film Cover Installation with Roll-Up Sides
Using a 1/4" x 2" carriage bolt (FAH005B) and nut
11.
(FALB01B), attach the square shaft to a tubing
adapter.
Slide the square shaft through the Twist-of-the-Wrist
12.
gearbox.
