8
Revision date: 06.04.10
End Panel Installation
END PANEL INSTALLATION (continued)
Repeat steps to install the next panel. Work from the center
14.
outward to install the remaining panels.
35' wide:
The center, upper panels include H-channel
installed on both sides and along the bottom edge. The
bottom H-channel is common between upper and lower
panels and connects the two panels.
Finish the end wall using two (2) 6' x 10' panels on the
15.
outer position of the end wall. Measure, cut, and install
panels as previously described.
Cut the outer 6' x 10'
panels so each is flush with the side wall hat channel and
installed side panels (if equipped) of the main building.
NOTE:
The edges of the two outer end panels must not
extend beyond the edge of the side wall hat channel and
installed sidewall panels. When installed, the panels of the
end wall and sidewall meet to form a finished edge at each
corner of the building.
Measure and cut a section of 104213 profile and install it
16.
along the outside edge of each outer panel to complete
installation (see drawing C).
Install a Tek screw to secure the H-channel to the frame in
17.
each place where H-channel crosses the end wall brace.
See letter D in the diagram below for an example.
Continue by reading the care and maintenance section.
18.
GROUND LEVEL
6' x 12'
Panel
6' x 8'
Panel
6' x 8'
Panel
6' x 8'
Panel
6' x 8'
Panel
6' x 8'
Panel
6' x 8'
Panel
6' x 8'
Panel
6' x 8'
Panel
6' x 12'
Panel
Trim
excess panel
Trim
excess panel
Trim
excess panel
Trim
excess panel
Trim
excess panel
Trim
excess panel
104213
C
D
D
D
D
D
D
Panel pattern may vary. Refer to the panel
diagrams located in the Quick Start section
for the layout of panels for your end wall.
Outer Panel
Outer Panel
35' Wide End Wall
104213
Sidewall Hat
Channel
104213
End
Panel
C
104213
Outer End Wall
Panel
