15
Step Three:
To pull the cover over the frame, attach ropes to both ends of the
cover conduit. Wrap the rope around the conduit a few times as shown below to
prevent it from slipping off accidentally.
Step Four:
Throw the ropes up and over the frame and then pull the cover over
the frame. You need one person at each rope for this step.
Step Five:
Center the cover front to back and side-to-side.
Step Six:
In the front and rear hems, locate the black straps.
Step Seven:
If either of your straps were shipped with a D-ring attached, you
must cut the D-ring off with scissors, as it is not used on this model.
Step Eight:
Fasten ratchets to the outside of the legs with a Tek screw in the
bottom hole of the ratchet
as shown below. There should be a few inches between the end of the cover and
the ratchet.
BACK PANEL FASTENING
In order to hold the back panel in place while pulling over the rest of the canvas, it
will now be secured to the building by using the 1” black strap in the included kit.
