16
Step One:
Cut off the excess strap leaving 12" in length.
Step Two:
Feed the strap through the center slot in the ratchet and tighten
slightly.
Step Three:
The hem containing the cover conduit needs to be slit or notched at
each leg where you will install a strap. If your cover was not notched at the
factory, continue with this step. Cut a 2" long slit in the hem just above the cover
conduit. Repeat this step on the other side of the hem so you can pass a 1" wide
strap over the conduit through the slits. Feed the both strap ends together
through the slot in the ratchet spool and tighten slightly. Refer to the photos
below.
