33
Revision date: 02.10.10
Drop-Down Sides Installation
Mark plate mounting hole locations and drill the holes.
3.
Use a 3/8" drill bit for the mounting holes.
NOTE:
Do not position the mounting plate in a location
where other frame components will interfere with
the installation of the drop-down panel components.
The axle mounting clamps are attached to the inside
surface of the rafter legs/ground posts in a later step
.
If an end panel is installed, carefully cut small holes
for the mounting bolts, and attach the mounting plate
on the outside as shown.
Using the
4.
3/8" x 3 1/2" carriage bolts and 3/8" nuts,
secure the 103544 plate to the outside of the rafter
leg/ground post.
If the end wall is covered with a fabric panel, use a
utility knife to cut a small X through the panel within
the 2" hole position of the mounting plate for the axle
and continue.
INSTALL THE DROP-DOWN PANEL (continued)
With the mounting plate installed, take the 103496
5.
gearbox, place it against the outside surface of the
mounting plate at the desired angle, and secure using
the bolts included with the gearbox.
NOTE:
The gearbox can be tilted to allow easier
access when using the crank handle.
Take two (2) pieces of 131S075 (75") pipe, slide the
6.
swaged end of one into the plain end of the other and
secure the joint using an FA4482B Tek screw.
Using the diagram below, attach the 103496 gearbox
7.
and assemble the remaining components as shown.
NOTE:
Attach the plain end of the 131S075 pipe to
the 102717 drive hub. Use the pipe insert to mark the
hole location and drill the hole. Actual components
may differ slightly from those shown in the diagrams.
During installation, have an assistant support the
loose end of the axle to prevent damage.
Diagram shows the assembled components.
1/2"
24"
Center of End
Rafter Leg/
Ground Post
Mark Plate
Mounting Holes
x
x
Ribbon board and
retaining board
mounted on the
outside of the frame.
Corner Cap
x
2" Axle Hole
1/4" x 2" bolt
and 1/4" nuts
131S075
Pipe (plain
end)
102717 Drive
(3 pieces)
Mounting bolts
included with the
mounting plate.
3/8" x 3 1/2" carriage bolts (FAG365B)
and 3/8" nuts (FALB04B) to mount plate to end rafter.
