4
3
Installation
Important
Before the installation, please make sure the installation surface can sustain at
least 3X weight of the bracket and the camera.
Step 1 Select installation mode, install camera bracket according to the exact installation mode.
Note:
First please pull the cable through exit hole on the installation surface or the bracket before
installing the bracket.
Users need to install expansion bolt first if the surface is cement (need to stick an installation
position map on the wall first to keep accordance between the installation hole of the
expansion bolt and the bracket), then install the bracket, as shown in Figure 3-1.
Users can skip the first step if the surface is wooden, and use self-tapping screws to install
bracket directly.
Step 2 Install the camera on the wall by using self-tapping screws.
Step 3 Unscrew the adjusting screws by using an L-shaped wrench in the accessories bag,
adjust the camera to a proper location which needs monitoring, then secure the adjusting
screws and fix the camera, as shown in Figure 3-1 (A and B).
Step 4 Connect the video output port of device cable to the back-end HCVR device, and
connect the power port to power supply.
Step 5 Adjust the lens zoom and focus to make video clear on the back-end HCVR device (it
also can be done via five direction buttons). So far, camera installation is completed.
