HD4112 Manual Rev. 2
Manual Rev 1.0
CLEARVIEW
A06, (177.5MHz)
2. INSTALLATION
2.1 What
’s
in the Box
One HD4112 Encoder / Modulator
One power cable
2.2 Connection
The HD4112 unit comes standard with 4 x HDMI inputs.
Use a quality 75
Ω
coaxial cable with
“F”
connectors from the unit
’s
RF OUT jack to the
distribution system or directly to a television.
Connect the power cord to an appropriately rated AC power outlet.
Once connected to power, the device turns on and it takes about 80 seconds to be
operational. Then the message
“I
nitial Please wait
”
appears on the display. After 80
seconds the message
“CLEARVIEW and the Frequency Out” will be displayed
from RF output 1. Other output channels can be displayed by pressing right or left arrow
buttons.
2.2.1 DEVICE Programming and Setup
Connect an Ethernet cable directly (no Cross Over cable required) to the Ethernet Port
on the rear panel of the encoder and then connect the Ethernet cable to an Ethernet switch
or connect an Ethernet Cable to your PC. The default IP address is
192.168.1.138
Make sure your PC has the same first 3 IP sections, eg. 192.168.1.xx and the 4
th
is different
from 138.
