4 IP output setting
4.1 Output A
4.2 Output B
4.1.2 Service IP
4.1.1 IP Out Port
(Same content with 4.1)
4.1.3 Output IP
4.1.4 Subnet Mask
4.1.5 Gateway
4.1.6 Port
5.2 Subnet Mask
5.3 Gateway
5.4 MAC Address
5.5 Reset Password
5.6 Web NMS Port
5.1 IP Address
Encoder Modulator
SW:XX HW:XX
5 Network setting
6 Saving Configuration
7 Load Configuration
7.1 Load Saved CFG
7.2 Load Defaut
8 Version
Encoder Modulator
SW:XX HW:XX
3.2 Initial Status
Switch on the device and after a few seconds’ initialization, it presents start-up pictures as
below:
DVB-T
: indicate the modulation standard of this device.
A/B:
to indicate the 4 carrier outputs
XXX.XX MHz
indicates the current output frequency (Range: 30~999MHz) of its
corresponding carrier output.
X.XX Mbps
: indicate the encoding bit rate of each encoding board respectively.
Start up…
Start OK…
DVB-T A XXX.00MHz
X.XXMbps X.XXMbps
Page 5
SD4260
S-Video/CVBS/YPbPr to DVB-T Encoder Modulator User Manual