3.3 General Settings for Main Menu
Press “Lock” key on the front panel to enter the main menu. The LCD will display the
following pages where user can configure the parameters for the device:
User can press UP/DOWN buttons to specify menu item, and then press ENTER to
enter the submenus as below:
1)
Alarm Status
The alarm indicator will turn on if there is no A/V signals inputting or outputting bit
rate overflows. User then can enter this menu to check the error type.
2)
Encode Setting
Under this submenu, the LCD will show “2.1 Input 1”, “2.2 Input 2” and “2.3 ASI”.
“2.1 Input 1” and “2.2 Input 2” respectively represent the two encoding boards and there are
two programs under each input. User could enter each program to select one interface as the
signal source and set the related video & audio parameters.
1 Alarm Status
2 Input Setting
3 Modulate Setting
4 IP output Setting
7 Loading Config
8 Version
2.1 Input 1
2.2 Input 2
2.3 ASI
2.1 Input 1
2.1.1 Program 1
2.1.2 Program 2
5 Network Setting
6 Saving Config
Page 6
SD4260
S-Video/CVBS/YPbPr to DVB-T Encoder Modulator User Manual