ООО "Бассейн-Сервис" – продажа и монтаж оборудования для бассейнов.
Тел: 8 (800) 700-65-50,
If the fuse was NOT BLOWN, and you get no output at all, check back of circuit board for anything unusual - loose parts, burn
marks, etc. If this is the case, return the CIRCUIT BOARD ONLY to your dealer or return to
Clearwater Enviro Tech,
prepaid
postage.
Clearwater Enviro Tech
will repair the unit at no charge if it is inside the 5 year warranty period (sales slip required or
returned warranty card on our file) and assuming all conditions were following as noted on the 5-Year Warranty Card. If the
unit is not covered under warranty, the customer will be notified by phone or writing as to what the charge will be to repair.
REMOVING THE CIRCUIT BOARD
If the control box needs to be replaced for any reason, the unit was designed so that only the circuit board needs to be
checked out. This allows for all external electrical connections and the enclosure to remain at the same location during repair.
To remove the circuit board, follow these steps:
A.) Unscrew the two (2) screws holding the clear cover.
B.) Lift clear cover.
C.) Lift up circuit board - under the decal.
D.) Unplug connector going to circuit board.
E.) Remove circuit board and return to dealer or to
Clearwater Enviro Tech.
Phone: 727-562-5186 • www.clearwater-enviro.com
