25
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water through the heater.
The pump that performs this function is known as the “heater pump.”
Your Clearwater Spa has a dedicated circulation pump that acts as your spa’s
heater pump. In
Ready Mode
, your spa water will automatically attempt to
maintain its set temperature. However, using the spa with the cover open during
extreme cold temperatures, the set temperature may be unattainable.
In
Rest Mode
, the spa will only heat to set temperature during programmed filter
times, even though the water is being filtered constantly when in Circulation Mode.
40985_F
12-08-11
6
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
The Settings Screen – Continued
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that performs this function is
known as the “heater pump.”
The heater pump can be either a 2-speed pump (Pump 1) or a circulation pump.
If the heater pump is a 2-Speed Pump 1, READY Mode will circulate water every 1/2 hour, using Pump 1 Low, in order to
maintain a constant water temperature, heat as needed, and refresh the temperature display. This is known as “polling.”
REST Mode will only allow heating during programmed filter cycles. Since polling does not occur, the temperature display
may not show a current temperature until the heater pump has been running for a minute or two.
While Pump 1 High can be turned on and off, Pump 1 Low will run until set temperature is reached, or 1 hour has passed.
Circulation Mode (See Page 8, under Pumps, for other circulation modes)
If the spa is configured for 24HR circulation, the heater pump generally runs continuously. Since the heater pump is always
running, the spa will maintain set temperature and heat as needed in Ready Mode, without polling.
In Rest Mode, the spa will only heat to set temperature during programmed filter times, even though the water is being
filtered constantly when in Circulation Mode.
Ready-in-Rest Mode
READY/REST appears in the display if the spa is in Rest Mode and the Jets 1 Button is pressed. It is assumed that the spa
is being used and will heat to set temperature. While Pump 1 High can be turned on and off, Pump 1 Low will run until set
temperature is reached, or 1 hour has passed. After 1 hour, the System will revert to Rest Mode. This mode can also be reset
by entering the Settings Menu and changing the Heat Mode.
Settings
Back
Temp Range
Heat Mode
Time of Day
Filter Cycles
Light Cycle
Invert Panel
Lock
High
Ready
`
`
`
Normal
`
Ready-in-Rest Mode
READY/REST
appears in the display if the spa is in
Rest Mode
and the
Pump 1
Button
is pressed. It is assumed that the spa is being used and will heat to set
temperature. Your circulation pump runs 24 hours a day and works to maintain
the set temperature. After 1 hour, the System will revert to
Rest Mode
. This mode
can also be reset by entering the Settings Menu and changing the Heat Mode.
Summary of Contents for Beachcraft Series
Page 57: ...57 NOTES...
Page 58: ...58 NOTES...
