1994b_1_5_en-bedingt.fm, 12.06.2014
P1993BA/EN 2014-06
11
Before initial operation
4
Oils according to DIN 51524 / ISO 3498
4.2
Change air inlet: top / bottom (only on 35PHHA)
When delivered, the air inlet is at the BOTTOM and sealed with a screw plug. To change the air supply from
top to bottom:
Remove the air strainer from the air inlet at the TOP (do not discard), see 8.2 Pistol grip 35PHHA…,
page 30, Detail
X
.
Remove screw plug from BOTTOM. When doing this, counterhold with wrench (WAF 17).
Seal the air inlet at TOP with screw plug in accordance with specifications.
4.3
Connect the tool
Connect the tool to the compressed air line.
Maximum screwing-in torque = 40 Nm. Reaction torque at flat end. Counterhold with wrench (WAF 17).
Activate compressed air: 620 kPa.
Lubricator
Compressed air requires a small amount of oil and is orientated to
the air consumption of the tool.
Calculate the time (
T
) between two drops of oil and make the
following settings at the lubricator:
F
= Factor for pulse nutsetter = 2
L
= Air consumption of tool at idle m³/min
(see performance data for pulse shut-off nutsetter)
Order
no.
Packaging
unit
Liter
Name
ARAL
BP
elf
ESSO
INA
Mobil
Klüber
SHELL
933090
2
HL32
Aralub
EE 100
Energol
HL 32
Polyelis 32
Olna 32
Nuto
H 32
Hydraol
32A
D.T.E.Oil Light
Vactra Oil Light
Crukolan 32
Molina 32
Molina 22
CAUTION!
The air hose can come off by itself and whip around uncontrollably.
Shut off the compressed air before making the connection.
Device
Explanation
T
60
F
L
-------------
=
