Tightening sequence
Apex Tool Group
P2398PM | 2022-07
59
4
EN
4
In the FastApps mode, there is a choice between two tightening sequences:
Torque shutoff: Sequence 31 torque controlled, extended monitoring
Shut-off torque-controlled tightening sequence with torque and angle check.
Fig. 4-1: Representation of torque shutoff
Angle shutoff: Sequence 51 angle-controlled, extended monitoring
Shut-off angle-controlled tightening sequence with angle and torque check.
Fig. 4-2: Representation of angle shut-off
The following description applies to both tightening sequences.
For the speed, select a second speed parameter
Final Speed
. The behavior at the Final Speed is different
in FastApps and mPro mode:
FastApps mode: If the
Final Speed
is programmed, the speed immediately changes from the start
speed to the final speed up to the maximum torque.
mPro mode: If the
Final Speed
is programmed, the speed is reduced from the starting speed to the
final speed starting from the threshold torque to the maximum torque.
