16
P1891E/EN 2014-02
1891b-enu_1_5_bedingt.fm, 25.04.2014
Product description
3
3.2.11
Wireless interface
Depending on the exact type, the tools are also equipped with a wireless interface in addition to the IrDA
interface.
The tool uses this wireless interface port for continuous communication with the controller. This
interface port is used to transmit both the parameters and the rundown results. Data transmission is possi-
ble in the
Active
,
Energy saver mode
and
Standby
operating modes, but not possible in
Sleep
(see 6.2
Operating status, page 21). Programming and setting up the wireless interface port are described in the pro-
gramming manual of the controller.
3.2.12
LiveWire Memory Chip (LMC), only for models of the series 47BAY(…)
To permit simple replacement of tools in production, a replaceable LMC memory module is installed. When
the tool is switched on, the network settings are read from the LMC chip and used to establish the WLAN
connection. When the tools are changed, the LMC has to be installed in the new tool being used. Please
refer to 5.5 Changing LMC, page 19.
The following data are stored on LMC:
The MAC address is defined by
Cleco
and cannot be changed. The other data can be changed via infrared
connection of the tool to the controller .
3.2.13
Platform, only for models of the 47BAYP(…) series
Tools with a platform are basic tools which can be fitted with different add-on parts. Scanners and tags can
be ordered individually.
Type
Communications
Required linking terminal
47BAR(…)
RF868 MHz
Basis station Order no. 961300
47BAX(…)
WLAN standard IEEE 802.11b
Access point to standard IEEE 802.11b
47BAY(…)
WLAN standard IEEE 802.11a/b/g
Access point to standard IEEE 802.11a/b/g
47BAZ(…)
WPAN standard IEEE 802.15.4
Basis station Order no. 961390 / 961410
After the tool is switched on, it can take up to 35 seconds until the communication is active.
•
MAC address
•
Use of the DHCP server
•
Country-specific settings
•
Network name (SSID)
•
IP address
•
Encryption
•
Subnet mask
•
Network key
•
Gateway
