8
When shipped, the PureSINE-1000se is configured for 220-230V AC
power operation at 50Hz. Before operating the PureSINE-1000se
make sure the AC mains connector label indicates the correct
operating voltage for the current location.
The PureSINE-1000se has three operating states:
1. Off
Power is disconnected from the AC mains connector.
2. Standby
Power is connected to a small power supply, and control circuits.
The PureSINE-1000se consumes less than 30W of power.
3. On
Power is connected to the AC mains connector and all power
components.
The PureSINE-1000se should be unplugged during lightning storms
and extended periods of non-use. Otherwise, it is designed for
continuous operation. For best performance, make sure power is
connected to the AC mains connector at all times. During normal
operation, do not use the power button (on the rear panel) to power
off the PureSINE-1000se. Instead, use the on/off button to place the
PureSINE-1000se into standby.
Power Requirements
Continuous Operation
Operating States
