35
36
Step 1
Rotate Recline Foot to Rear-Facing position by
pulling on edge of Recline Foot and rotating it
towards the front of the seat until it locks in to
position, as shown in
Figure 39
.
• Anti-Rebound Bar must also be securely
attached to the seat, see “Installing/
Removing Anti-Rebound Bar” on page
73.
Step 2
Select a Forward-Facing vehicle seating
location which has UAS.
Locate the UAS anchors as shown in
Figure
40
. See “Vehicle Universal Anchorage System
(UAS)” on page 25 in this manual and check
your vehicle owner’s manual for further
information.
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 41
.
Figure 40
Figure 39
Figure 41
lowered recline foot
Raised recline foot
Step 4
Remove Seat Cushion, see “Removing/
Installing Seat Cushion” on page 72.
Remove UAS belt from its storage location
under the Seat Cushion, see “UAS Belt
Storage” on page 76.
Lengthen the UAS belt by pressing the
adjuster release button while pulling belt to
extend the length of lower anchor belt as
shown in
Figure 42
.
Step 5
Route UAS Belt through the Rear-Facing Belt
Path, taking care that there are no twists in
the UAS Belt. UAS belt adjuster must be on
the right side of the seat when facing it, as
shown in
Figure 43
.
Step 6
Position UAS Belt under Belt Tabs and over
both Rear-Facing Belt Lock-offs as shown in
Figure 44
.
Check that Crotch Strap is not under UAS Belt
as shown in
Figure 44a
.
Figure 42
Figure 43
Figure 44
Figure 44a
