45
46
IMPORTANT:
If Lock-off will not close easily,
it may be necessary to loosen the belt slightly
in order to properly position the belt under
the Belt Tabs and close the Lock-off.
Check that the entire lap/shoulder belt (both
the lap and shoulder portions of the belt) is
through the Rear-Facing Belt Lock-off being
used and under all four Belt Tabs as shown in
Figure 60
. Close-up of Belt Tabs is shown in
Figure 60a
.
NOTE:
If your vehicle’s belt system is
equipped with an ELR/ALR switchable
retractor (SLR), it is also recommended to
engage the ALR by slowly pulling the vehicle
belt all the way out until it stops. Then, feed
the belt back into the retractor.
Option 2 — Installing with lap/shoulder
belt WITHOUT using a Rear-Facing Lock-off:
Tighten vehicle belt to secure the car seat
• Engage the vehicle’s ALR by slowly
pulling the vehicle belt all the way out
until it stops. Then, feed the belt back
into the retractor.
Figure 62
Figure 63
Figure 64
• Press down in center of car seat to
depress the vehicle cushion and pull the
shoulder portion of lap/shoulder belt to
tighten as shown in
Figure 61
, feeding
any remaining belt webbing back into
the retractor.
Check that the entire lap/shoulder belt is
under all four Belt Tabs and over both Rear-
Facing Lock-offs as shown in
Figure 62
.
Option 3 — Installing with lap-only belt:
Tighten vehicle belt to secure the car seat
• Press down in center of car seat to
depress the vehicle cushion and pull the
end of the lap belt to tighten as shown in
Figure 63
Check that the entire lap belt is under all four
Belt Tabs and over both Rear-Facing Lock-offs
as shown in
Figure 64
.
Figure 61
Figure 60
Figure 60a
