55
56
Step 7
Check that the entire UAS belt is laying flat,
placed correctly through the Forward-Facing
Belt Guides, and NOT between the Harness
and seat, as shown in
Figure 74
.
Step 8
Place car seat Forward-Facing in the vehicle
seating location selected, and connect each
UAS lower connector to each corresponding
vehicle UAS anchor. For each connector:
• Press the UAS Connector against the
UAS anchor until you hear the UAS
Connector click, as shown in
Figure 75
.
• Pull on UAS Connector to check that it
is securely locked on the vehicle UAS
anchor.
IMPORTANT:
Check that there are no twists in
the UAS belt, and that UAS belt is contained
in both red Forward-Facing Belt Guides.
Step 9
Position car seat so it is touching the vehicle
seat back, and tighten UAS belt to secure it.
• Press down in center of car seat to
depress the vehicle seat cushion, and
pull on the end of the UAS belt to tighten
as shown in
Figure 76
.
Figure 76
Figure 75
Figure 74
Figure 77a
Figure 77
Figure 51
Figure X
Figure X
Step 10
Attach Tether Hook to vehicle top tether
anchor as shown in
Figure 77
or
77a
and
pull firmly on free end of strap until Top
Tether is snug.
Refer to vehicle owner’s manual for
recommended Top Tether routing and
identification of top tether anchor point.
Step 11
Gripping car seat at top of armrests, pull car
seat front to back and left to right to check
for secure installation as shown in
Figure 78
.
UAS belt and Top Tether must stay tight and
child restraint should not move more than 2.5
cm (1”) in any direction.
• If UAS belt does not stay tight or car
seat cannot be securely installed, try a
different UAS location or install using
the vehicle belt, see “Installing Forward-
Facing Car Seat With Vehicle Belt” on
page 59.
Figure 78
