FUNCTIONING
GIAMPY
Rev. 00
15/02/2012
Pag. 29/43
4.7.5 REGULATION OF THE DETERGENT SOLUTION
The quantity of detergent solution during the scrubbing operation can
be easily regulated by a lever placed in the back-left side of the machine
(picture 4.10 particular 1)
N.B.: if it is necessary to set the regulation of water quantity make sure that the ignition key
is disconnected to avoid casual starting.
4.7.6 SQUEEGEE ADJUSTEMENT
To guarantee a perfect drying, is essential that the squeegee is perfectly regulated.
This squeegee, is well done to pick up the water to the suction pipe, but is too sensitive face to the ground
level. To regulate the squeegee, is necessary :
Remove the ignition key to avoid casual starting.
To regulate the parallelism of the squeegee with the ground it needs to act on its own handles
(detail1 picture 4.11).
To regulate the slope of the squeegee it needs
to act on the knob (detail 2 picture 4.11) which
1
allows to increase or lower the edge between
squeegee and floor.
2
It’s very important that the two wheels are well set to keep the blades of the squeegee in
parallel and well placed to the ground.
PICTURE N° 4.10
PICTURE N° 4.11
1
