SAFETY
Ecosmart
Rev. 000
29/11/2012
13/38
05 ACCELERATOR PEDAL
FAULT
The accelerator potentiometer is not working. The machine is
blocked. Reset to re-start. After restarting, until the pedal of the
accelerator is pushed again and the fault condition persists, the
rest of the machine starts working again.
06 START BLOCK
Intervenes when on start-up the advancement pedal is pushed and
the panel switches on. It is signalled to prevent an uncontrolled
start. The error persists only if at least one of the three conditions
occurs: pedal pressed, consent to move forward active, consent to
move back active. When the error disappears (with re-start) the
machine returns to working normally. In the error condition, the
rest of the machine works and only traction is blocked.
07 MAXIMUM TRACTION
TEMP.
Traction thermal protection intervenes. The machine is blocked.
Reset on start-up. Once restarted the electronics display all the
default values: all the utilities are off, the speed adjustments are
set to the value chosen by parameter, the jacks are lifted, no
consent for operation. The error is re-proposed only if traction is
started and absorption is anomalous. Therefore until the traction
starts the rest of the machine functions normally.
08 MAXIMUM BRUSHES
TEMP.
Thermal protection intervenes on the brush motors. The value of
absorbed current is too high. The machine is blocked.
Reset on start-up. Once restarted the electronics display all the
default values: all the utilities are off, the speed adjustments are
set to the value chosen by parameter, the jacks are lifted, no
consent for operation. The error is re-proposed only if the brushes
are started and absorption is anomalous. Therefore until the
brushes start the rest of the machine functions normally.
09 MAXIMUM SUCTION
TEMP.
Thermal protection intervenes on the suction. The value of
absorbed current is too high. The machine is blocked.
Reset on start-up. Once restarted the electronics display all the
default values: all the utilities are off, the speed adjustments are
set to the value chosen by parameter, the jacks are lifted, no
consent for operation. The error is re-proposed only if suction is
started and absorption is anomalous. Therefore until suction starts
the rest of the machine functions normally.
10 BATTER LEVEL LOW
The charging level is critical. Use of the brushes is prohibited.
Plate up.
The rest of the machine is working. The message stays on. Buzzer
cycle: a beep for 5 seconds followed by a two minute break.
Reset on start-up, if the voltage returns to being superior the error
disappears.
11 BATTERY LEVEL VERY
LOW
The charging level is very critical. Use of the brushes is forbidden
as well as use of the suction device. Squeegee and brushes plate
up. Only traction works. The message stays on. Buzzer cycle: a
beep for 5 seconds followed by a one minute break.
Reset on start-up, if the voltage returns to being superior the error
disappears.
12 BATTERY FLAT
Blocks the machine. The charging level is such that further
operation of the machine would prejudice the integrity of the
batteries. The error persists until the charging level returns to
normal.
13 RECOVERY TANK FULL
Tank is full. Suction is forbidden and squeegee up.
The rest of the machine works. Reset on start-up. Once emptied
the error disappears.
14 BRUSHES JACK BLOCK
The short-circuit protection intervenes on the brush actuator. The
value of absorbed current is too high.
It is only forbidden to activate the jack and the brushes motor. The
rest of the machine is working. Reset on start-up.
15 SQUEEGEE JACK BLOCK
The short-circuit protection intervenes on the squeegee actuator.
The value of absorbed current is too high.
It is only forbidden to activate the jack and the suction motor. The
rest of the machine is working. Reset on start-up.
