SAFETY
Ecosmart
Rev. 000
29/11/2012
15/38
3.8 OTHER DANGERS
FIORENTINI S.p.A. analyzes starting from the design of the machine - all the dangers that can occur while
the machine is operating in order to prevent or at least lower the operator’s accidents. Thanks to a series of
signals on the machine the operator can avoid many risks that can occur.
CRUSHING
This kind of danger can occur:
•
During the side brushes regulation;
•
during the batteries recharge because of the fall of the recovery tank.
Whilst regulating the side brushes, the ignition key must be kept away from the dashboard in order
to avoid the casual starting of the machine.
Whilst the batteries recharge, the operator must pay attention that any parts of his/her body enter the
batteries room.
Special labels sticked on the carters of the brushes or on the recovery tank prevent
dangers to the operator.
SQUASHING AND SHEARING
This kind of danger can occur:
•
while the operator is regulating the steering wheel by means of the pedal.
The operator must only use his/her legs during the regulation of the steering column.
Squashing and shearing danger is highlighted by special labels sticked on the case of the steering
column.
TURNOVER
This kind of ranger can occur:
•
during the normal operating of the machine when you exceed sloping limits as specified in
the manual and you use the machine to clean disconnected surfaces or with holes and high
depressions.
•
Do not use the machine to wash surfaces with a slope greater than 10% at
rate 'exceeding 3 km / h or surfaces with holes, bumps and bumps in general
likely to jeopardize the stability of the machine.
Fiorentini disclaims any liability for accidents to persons or property resulting from the
machine on surfaces that can affect the stability of the machine. The buyer must arrange for
suitable signage to inform the user about the status and condition of surfaces on which it
must operate.
