STARTING AND USE INSTRUCTIONS
Ecosmart
Rev. 000
29/11/2012
23/38
4.7. FUNCTIONING
The washing operation is very delicate as it is needed, based on experience, to judge correctly the type of
brush to use, good choice of detergent and whether or not a double cleaning action. To perform the washing
operation, you must click on the symbol of the power machine (see Fig.4.6 part.8): automatically light up the
brushes (the solenoid is activated and if 'any), will subside' brushes through the plate jack and will also turn
on the vacuum. This will allow 'the user to already be' ready to use the washer-dryer without calling any other
function. To return to the home position you simply press the switch.Completed the washing operation,
before finishing drying, you should close the tap water because it is independent of the start button. If the
floor is very dirty, it is advisable to a double action for cleaning: it will have to perform a first phase with the
squeegee in the raised position and the brushes in the working position; initiated the brushes and the lever
open water, will carry out a first passed, on a surface of some tens of square meters. The cleaning solution
must be left on the floor to loosen the dirt, with completion of its function as a solvent, until it will be collected
with the second pass. Of course, the second cleaning action to be carried out with the brushes lowered, the
lever open water and the squeegee in contact with the floor (switch suction activated).
4.7.1 PREPARING AND STARTING THE MACHINE
If the cleaning machine is connected to the charger, you must unplug the charger from the plug coming from
the car battery and connect the plug of the battery with the power plug from the machine (see picture 4.5); to
load water by unscrewing the filler cap. (part.1 picture 4.7).
The machine can now be activated by turning the main switch key with operator sitting at the edge. At this
point it can be flushed.
4.7.2 CHOOSING THE RIGHT DETERGENT
Choosing the right detergent is very important for a perfect cleaning. A too strong detergent could damage
the surface. A good quality detrgent has to produce little foam. Alternatevely, the operator can add an
antifoaming additive or 50 cc of wine vinaigre in the recovery tank in order to avoid the suction motor
damage.
Make sure that the detergent is suitable for the dirty surface. FIORENTINI S.p.A. is not
responsible for damages provoked by too aggressive detergents.
PICTURE N° 4.7
1
