Maintenance
1. During interruptions of the cleaning process, always place the lance
into the holder of body. And always place the machine upright on dry
fl
oor surface.
2. When the water drop disk is full, please empty and wash it, and then
install back to body.
3. The yellow rubber bung must be pushed to the inlet hole, when you
finish the fluid input. Otherwise dirt will infect the water tank.
DO NOT put any other fluid into the tank unless approved
by the manufacturer.
4.
Make sure the batteries are charged 100% on the first charge.
Machine maintenance
The BATTERY VERSION I-GUM machine requires very little maintenance. Wipe down the
machine periodically with a clean cloth. And wipe down the lance, and change the new brush
for the lance. DO NOT spray water directly over the top of machine or top connector cap.
5. The top cap for hose connector is assembled by the factory,
DO NOT disassemble the hose connector cap unless qualified.
The connectors are showed as the picture:
connect to 2 poles
circle male connector
connect to transparent
pipe 6x4mm
connect to 7 poles
circle male connector
12
