OPERATION
20
T12 9009918 (3--2013)
STARTING THE MACHINE
FOR SAFETY: Before starting machine, adjust
seat and fasten seat belt (if equipped).
1. Sit in the operators seat.
2. Turn the
Key switch
completely past the On
position and release the key switch. The key
switch will automatically return to the On
position.
3. Place the
Directional switch
into the direction
needed to travel.
4. Press the
Propel pedal
to move the machine.
NOTE
:
The machine will not travel unless the
operator is sitting in the operator seat.
FILLING THE SOLUTION TANK
ec- H2O SCRUBBING (ec- H2O MODE)
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
1. Remove the cap from the solution tank.
2. Fill the solution tank with only clean COOL
WATER (less than 21
q
C / 70
q
F). DO NOT use
hot water or add any conventional floor
cleaning detergents or an
ec--H2O
system
failure may result. Fill the solution tank with
water until the level is approximately 50 mm
(2 in) below the cap.
WARNING: Flammable materials can
cause an explosion or fire. Do not use
flammable materials in tank(s).
NOTE: Do not use the ec--H2O system when
there are conventional cleaning detergents in the
solution tank. Drain, rinse, and refill the solution
tank with clear cool water before operating the
ec--H2O system. Conventional cleaning
detergents may cause an ec--H2O system failure.
3. Reinstall the cap onto the solution tank.
