RADIUS SL PLUS 03.2019 en
17
Figure 10 Return into the tank
Attention:
As soon as the oil supply is switched on, the RADIUS blade share moves outwards. This is
particularly important when the unit is lifted, as it may cause injury. The unit should only be
switched on at the place of use, please keep your distance!
6.2.2 De-aeration
a) The units are vented with the oil flow is switched on. All valve levers connected to the RADIUS units should
be placed in the operating position for some time. Move the sensor rod and thus also the device by hand. Now
the system deareates automatically.
b) After the hydraulic system has been vented and filled with the hydraulic oil, it is necessary to check the oil level
of the tractor's hydraulic system and, if necessary, top up with oil.
6.2.3 Adjustment - setting at the factory
Figure 11 Sensor rod end stop inwards
Figure 12 Sensor rod end stop outwards
The devices are precisely adjusted and tested at the factory. If the setting should have changed in the course of
time, the device must be reset as follows:
Suction filter
Pump
8
7
4
2
1
6
5
3
