35
9.4.l Re-configure control
When exchanging components, control or Poolmaster, these must be
reconciled (only possible in the protected part).
Control
- Go to the protected area
- Press button 3/4 to go to Display indication (G).
- Turning off the power of the whirlpool for 5 seconds
- Turning on the power again
- Turn on “Init CT” with button 1 on the Poolmaster
- Wait until the configuration is complete (LT F 0 changed to LT F 1). This
change can take up to one minute.
Back to menu-level 1
Press the button to call up the empty menu window (H) and select “End”
with button 1.
7 Instellingen
Verlichting
Aan Uit
7
Instellingen
Einst.
7 Instellingen
Systeem
O pties
7 Instellingen
Pincode
-
1
+
7 Instellingen
Aud C h0
LTF 0 AC F 0
LTI 0 AC I 0
Init AC
Init CT
7 Instellingen
Einde
9.4.k Activate / deactivate the function of the Whirlpool (H)
(Only possible in the protected mode, and only if the whirlpool is equipped with the corresponding
function!) Press button 4 to go to the function (eg halogen). Activate / deactivate the function (eg
halogen) with button 1.
9.5 Cleaning function
When the bath is drained, the Hydro button (button 3) starts to flash until the bath is completely
empty. After approximately 6 minutes, the Air system is automatically switched on and removes the
residual water from the mains and the jets.
Summary of Contents for Complete Wellness
Page 19: ...19 User manual...
Page 37: ......
