GENERAL
Installation of the unit must be accomplished by
qualified installation personnel working to all
applicable local and national codes. Improper
installation of product could cause injury or damage.
This unit is built to comply with applicable
standards for manufacturers. Included among
those approval agencies are: UL, NSF,
ASME/Ntl.Bd., CSA, ETL, CE, and others. Many
local codes exist, and it is the responsibility of the
owner/installer to comply with these codes.
INSPECTION
Before uncrating, visually inspect the unit for
evidence of damage during shipping. If damage
is noticed, do not unpack the unit, follow shipping
damage instructions.
SHIPPING DAMAGE
INSTRUCTIONS
If shipping damage to the unit is discovered or
suspected, observe the following guidelines in
preparing a shipping damage claim.
1.
Write down a description of the damage or the
reason for suspecting damage as soon as it is
discovered. This will help in filling out the claim
forms later. If possible, take a polaroid picture.
2.
As soon as damage is discovered or suspected,
notify the carrier that delivered the shipment.
3.
Arrange for the carrier's representative to
examine the damage.
4.
Fill out all carrier claims forms and have the
examining carrier sign and date each form.
CLEARANCE REQUIREMENTS
The first installation step is to refer to the
SPECIFICATION DRAWINGS at the back of this manual
in order to determine the exact location of the kettle.
CLEARANCE REQUIREMENTS TO
COMBUSTIBLE AND NONCOMBUSTIBLE
SURFACES:
RIGHT
LEFT
BACK
KDT-1-T
4"
0"
0"
KDT-3-T & KDT-6-T
4"
4"
1"
KDT-12-T & KDT-20-T
4"
4"
1.75"
Note:
For SD Stands (with or without kettles) zero
clearance is required on the sides and back.
KETTLES
Table-top models must be positioned on a firm stand
or existing counter top and secured in place. An
optional modular cabinet base (SD Stand), with
level-adjustable legs is available .
1.
Make two 1" holes for
the kettle legs.
2.
Remove the leg mounting
locknuts and washers from
the kettle's legs.
3.
Install the legs into the two
1" holes.
4.
Position washers as
illustrated and secure
the kettle to its' base by
refastening the locknut
from underneath the
cabinet or countertop.
5.
Once the kettle is secure,
screw the tilt handle into
the mounting block welded
to the side of the kettle.
6.
Install service requirements
as required.
KETTLES c/w SD STAND
1.
Place unit in desired location.
2.
Place a carpenter's level on the kettle rim and
level the stand using the level adjustable feet.
3.
Install service requirements as required.
INSTALLATION
A
DRILL TWO
1" HOLES
A
KDT-1-T
8 1/8"
KDT-3-T
10"
KDT-6-T
12"
KDT-12-T
19 1/2"
KDT-20-T
23 3/4"
COUNTERTOP
