ON BUTTON
Power On / Pause / Restart
AUTO BUTTON
Automatically cycle through pre-set
colour phases (366).
OFF BUTTON
Turn off (Autosaves current sequence
when turned off).
SPEED BUTTONS
Adjust speed of light transitions.
S+ : Increase Speed
S– : Decrease Speed
BRIGHTNESS BUTTONS
Adjust Lighting brightness.
: Increase Brightness
: Decrease Brightness
MANUAL BUTTONS
Manually cycle through pre-set
transitions (366).
M+ : Cycle up through colour phases
M– : Cycle down through colour phases
PRE-SET COLOURS
Select from a range of 12 pre-set
solid colours.
BLUE BUTTON
PINK BUTTON
Press and hold for 5 seconds to pair
RF Remote Control to this lighting only.
(No other remote can control lighting).
WHITE BUTTON
Press and hold for 5 seconds to
allow multiple RF Remote Controls
to operate LED Strip.
BATTERY COMPARTMENT
Battery compartment located
on rear of remote. Requires: 1 x 3v
CR2025 Lithium Battery (Supplied).
A
B
C
D
E
F
G
H
I
J
K
A
D
E
H
J
I
G
C
F
B
POWER
RED
GREEN
BLUE
1. Remove the plastic tab
from the battery
compartment on the
rear of the remote.
2. Turn off lighting using
the OFF Button
(C)
3. Press the ‘AUTO’
button
(B)
to enter the
configuration mode.
4. Press the ‘BLUE’ button
(H)
until the LED’s
display Red, Green, Blue in order from the
start of the Light Strip (see below diagram).
5. Press the OFF Button
(C)
to store the setting
INSTRUCTIONS
09
HOW TO USE YOUR CLEVERSPA
®
LED LIGHTING RF REMOTE CONTROL
INITIAL LIGHTING SETUP
K
SS19 6 Person Square CleverSpa IM_AW.indd 9
30/10/2018 15:30
