NPM User Manual
10
r "OPEN" can be read on the screen if connected. The word "YES" in red will flash if smoke
d
d when connected. The word "YES" in red will flash if water-logging alarm happens.
re the device series number, input outlet name as well as the interval of sequential power on/off, details as
n not normally monitor and manage the
ch as long as 20 bytes;
Interval": configure it according to specific requirement; the interval is between 0 to 255 seconds.
address
、
Sub-net Mask
、
default gateway DNS according to different application environment, details
.255.255.0
is 0.0.0.0, any DNS address of normal domain name resolution, make sure the
iguration information will be valid after system reboot.
the time of power on/off, the device automatically switch on/off according to the set time, details as
peat", the device will automatically power on/off daily according to the time set by user if setting
ent, temperature/humidity threshold and ensure the devices operation well in normal status, details as
c)
"Smoke alarm" displays the connection of smoke sensor, "Not found" means no smoke alarm is connected. The
word "CLOSE" o
alarm happens.
d)
"Water logging" displays the status of water sensor, "Not found" means no water sensors is connected. The wor
"YES" or "NO" can be rea
3)
Device Configuration
Configu
below:
a)
" NPM Address No": each device has a unique series number; the user ca
device if the displayed figure is not the same as the device series number.
b)
" NPM name": configure the device name which can rea
c)
Configure outlet name, it can reach as long as 35 bytes;
d)
"Sequence
4)
Network
Configure IP
as below:
a)
IP address: LAN or WAN IP address, the default IP is 192.168.1.163
b)
Sub-net Mask: correspond with IP; the default sub-net mask is 255
c)
Gateway: correspond with IP; the default gateway is 192.168.1.1;
d)
DNS address: the default DNS
e-mail can be send successfully
Note:
network conf
5)
Timing Control
Configure
below:
a)
Click on “Setting" to adjust time and make sure the time is the same with the PC
b)
"ON Timing" time of power on setting, the format is: yy/mm/dd hours: minutes:
"OFF Timing" time of power off setting, the format is: yy/mm/dd hours: minutes:
c)
Select "Re
success.
6)
Threshold Value
Set curr
